Type: Driver
File Name:
File Size: 32.8 MB
13 (3.34)
Downloads: 8
Supported systems: Windows XP, Windows Vista, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10, Windows 10 64 bit
Price: Free* (*Free Registration Required)

Download Now

May The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer. In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use the product or ADLINK cPCI-7841, even if advised of the possibility of such damages. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of ADLINK cPCI-7841 manufacturer.

It supports dual ports CAN s interface that can run independently or bridged at the same time.

The built-in CAN controller provides bus arbitration and error detection with auto correction and retransmission function. The PCI cards are plug and play therefore it is not necessary to set any jumper for matching the PC environment. The CAN Controller Area Network is a serial bus system originally developed by Bosch for use in automobiles, is increasing being used in industry automation. The card should be done on a grounded anti-static mat. ADLINK cPCI-7841


The operator should be wearing an anti-static wristband, grounded at the same point as the anti-static mat. Inspect the card module carton for obvious damage. Shipping and handling may cause damage to your module. Be sure there are no ADLINK cPCI-7841 and handing damages on the module before processing. After opening the card ADLINK cPCI-7841 carton, exact the system module and place it only on a grounded anti-static surface component side up. Save the shipping materials and carton in case you want to ship or store the product in the future. Under normal circumstances, you should not need to change the jumper settings. A jumper switch is closed sometimes referred to as "shorted" with the plastic cap inserted over two pins of the jumper.


A jumper is open with the plastic cap inserted ADLINK cPCI-7841 one or no pin s of the jumper. The base address of the PM is restricted by the following conditions. The ADLINK cPCI-7841 address must be within the range hex to 3F0hex. The default base address of your PM is set to hex in the factory see Figure below. F OFF 1: The jumper setting is specified as below: Be aware that there is no other add-on cards sharing the same interrupt level in the system. Acceptance Code for CAN controller.

Acceptance Mask for CAN controller. Baud rate setting for the CAN controller.

CONFIG_CAN_PLX_PCI: PLX90xx PCI-bridge based Cards

It is used by the CanGetPortStatus functions. CAN ID field bit unsigned integer rtr: Length of data field.

Data 8 bytes maximum time: Reserved for future use reserved: It is widely used by the DeviceNet layer functions. Address of destination.

Caninstallevent – ADLINK PCI-7841/cPCI-7841 User Manual

Address of source. Message ID of DeviceNet packet len: Memory Mapping Range Return Value A bit unsigned integer High byte is the major version Low byte is the major version Remarks Call this function to retrieve the version of current using driver. This function is for your program to get the ADLINK cPCI-7841 of library and dynamic-linked library. Under DOS operation system, you will receive 1 if there is not enough memory. If writing program for the Windows system. It will return -1, if you want to open a port had been opened. And you must use CanCloseDriver to close the port after using. The properties of a CAN port such as baud rate, acceptance code, acceptance mask, operate mode. After configuration is over, the port is ready to send and receive data.

PCI+cPCI_Manual_7 Integer (Computer Science) (18 views)

PCI/cPCI Dual-port Isolated CAN Interface Cards. REQUEST QUOTE. Key Features.

  • ADLINK cPCI : CompactPCI Dual Port Isolated CAN Cards
  • Form Factor: CompactPCI, Manufacturer: ADLINK
  • ADLINK Cpci-7841 Dual-port Isolated Can Interface Card I01
  • CONFIG_CAN_PLX_PCI: PLX90xx PCI-bridge based Cards

ADLINK cPCI-7841 PICMG® Rev ; Dual-independent CAN network. cPCI ADLINK Technology Interface Modules DUAL-PORT ISOLATED CAN INTERFACE CARD datasheet, inventory, & pricing.

Other Drivers