3COM 3C16850 DRIVER DETAILS:

Type: Driver
File Name: 3com_3c16850_29038.zip
File Size: 40.8 MB
Rating:
3.04
12 (3.04)
Downloads: 6
Supported systems: Windows 10, Windows 8.1, Windows 7
Price: Free* (*Free Registration Required)

Download Now
3COM 3C16850 DRIVER



HP ENVY x2 11-g009tu Broadcom WLANRelated titles
Asus M4A77D Realtek LANAbout this product
Acer Aspire Z57303Com Other Networking Equipment Brands

The port shown in Figure 25 displays and you can set serial port parameters. Set the following parameters: The HyperTerminal dialogue box displays, as shown in Figure Power cords have been properly 3Com 3C16850.

  • 躍星科技有限公司 - 網路產品
  • 3Com Switch Starter Kit - switch - managed - desktop Series Specs - CNET
  • 3Com – IT Hardware Parts Catalog page 10
  • 3COM 3C16850 SWITCH 7700 7-SLOT STARTER KIT
  • Ask a Question
  • Switch Management

The voltage of power supply can meet the requirements on the switch. The console cable has been connected properly. The PC 3Com 3C16850 terminal for configuration has been started. The terminal parameters have been set.

3COM 3C16850 DRIVER UPDATE

The terminal displays the following information: RAM Line OK System is booting Creation date: Mar 25 Please check LEDs LEDs selftest finished! Switch chip selftest CPLD selftest The switch Mac address is To perform decompression immediately, press ESC while this 3Com 3C16850 is displayed. If you do nothing, the system enters the following auto-booting port within 5 seconds: Auto booting file is sw OK Decompress Image Starting at 0x Press Enter and the terminal 3Com 3C16850 displays: Upgrading the Software Image To upgrade the software image of a Switchuse one of the following procedures: A Fabric from a 7-slot chassis should be installed in Slot0 in an 8-slot chassis and must be upgraded to V3.

After you install the redundant Fabric module, you must wait for a few minutes until a CLI message 3Com 3C16850 that the secondary Fabric is ready, then save the configuration. Use the management port on the Fabric to download code.

DRIVER FOR 3COM 3C16850

You must set the boot-loader file to the V3. 3Com 3C16850 you upgrade both Fabrics, you must reboot the switch.

Do 3Com 3C16850 issue the reboot command. As the system reboots, the Fabric in Slot0 will return to primary status. In the following examples, the IP address of the local computer is Actual IP addresses and filenames will depend on your system and 3Com 3C16850 versions.

The following example illustrates this procedure: Now user privilege is 3 level, and just commands which level is equal to or less than this level can be 3Com 3C16850. Privilege note: May 26 Please check ledsThe 3Com Switch starter kit provides the foundation for delivering performance, security and quality of service in a modular seven slot chassis. The starter. 3Com Switch 3Com 3C16850 switch - managed overview and full product specs on CNET.

Other Drivers