Type: Driver
File Name:
File Size: 39.7 MB
11 (4.12)
Downloads: 7
Supported systems: Windows 2008, Windows XP, Windows Vista, Windows 7/8/10
Price: Free* (*Free Registration Required)

Download Now


Page 16 The system board supports two manageability features: ASM Pro detects problems in: Page 17 The system board has the following major components: System Board Layout Figure Acer Altos 1100 the system board components. Jumpers And Connectors This section describes the jumper and connector locations and settings. Figure shows the jumper and connector locations on the system board. Page 20 Table lists the system board jumpers with their corresponding settings and functions. Page 21 Table lists the different connectors on the system board and their respective functions. Page 23 The following figure shows the pin orientation of the front-panel connectors. Page 24 Before you install any system component, please read the following sections.

Acer Altos - PII MHz - Monitor : none. Series Specs - CNET

These sections contain important ESD precautions, pre- and post-installation instructions. Page 25 Electrostatic discharge ESD can damage your processor, disk drives, expansion boards, and other components. Always observe the following precautions before you install a system component. Do not remove a Acer Altos 1100 from its protective packaging until you are ready to install it.

Acer Altos 1100 Series Manuals

Jumper Settings Observe the following procedures after installing a system component: Check that the components are installed according to the instructions in their respective sections. Make sure you have set all the required jumpers. See section 1. Press the processor module down until Acer Altos 1100 edge connector snugly fits into the socket.

Page 28 2. Press the latches on the sides to lock the processor module into place.


Unlock the latches that secure the processor module. Page 29 2. Firmly hold the processor module and pull it out of the socket. Page 30 When you use only Acer Altos 1100 CPU, you must have a termination board installed in the empty slot.

Follow these steps to install the termination board: Position the termination board over the empty slot. Carefully insert the golden fingers Acer Altos 1100 the termination board into the slot until the board fits completely. Each of the sockets represents one independent bank.

This allows you to install DIMMs with Acer Altos 1100 capacities to form a configuration. Table lists some system memory configurations. Follow these steps to reconfigure the system: Power on the system. A memory error message appears, indicating that the total memory does not match the value stored in CMOS.

Acer Altos R380 F3

Press 3. Page 34 To install 32 bit PCI cards: Locate the PCI slots on the system board. Remove the bracket on the Acer Altos 1100 opposite an empty PCI slot. Insert a PCI card into the slot.

Acer Altos e MyBroadband Forum

Make sure that the card is properly seated. Follow these steps when installing an AGP card:Acer Altos - MDT - PII MHz - 64 MB - GB overview and full product specs on CNET. Acer Altos E - MDT - PIII MHz - MB - GB overview and Acer Altos 1100 product specs on CNET.

Other Drivers