Type: Driver
File Name:
File Size: 20.9 MB
15 (4.26)
Downloads: 11
Supported systems: ALL Windows 32x/64x
Price: Free* (*Free Registration Required)

Download Now

You just want that chunk gone and not grind down adjacent parts of the heatsink. Once happy with what was removed 5 minutes then blow away any aluminum shavings from the heatsink with a can of air or your method of choice as long as you remove ALL aluminum particles. Take note of where thermal pads are installed on the MSI GT60 2QD Dominator 3K Edition EC card. Remove the Clevo heatsink by removing the four screws that hold it on and gently pull it off the GPU core.

Clean off the GPU core with a few Q-tip swabs until clean. Remove the annoying heat spreader by using only thumb nail pressure against the parts of the spreader that come through the screw holes toward the top of the card. Press them until they are pushed back through the hole to about even with the card one at time spreader will not come off yet. This takes about 5 minutes. Install your new GTX M by gently pushing the card into the GPU slot at a slight angel and once in all the way into the slot the card will easily sit down in line with the screw hole that holds the GPU in place. Replace the screw that holds the GPU in place MSI GT60 2QD Dominator 3K Edition EC fasten tightly.

Optional - gently place the modified original heatsink onto the card and carefully observe that the heatsink isn't hitting Anything when it's sitting in the right place on the GPU. Notice that it's a pretty tight MSI GT60 2QD Dominator 3K Edition EC so be careful and remove the heatsink for the next step.

BIOS-Service-Center eBay Stores

Apply quality thermal paste to the entire GPU core. It is not necessary to have a thick coating and in fact putting too much thermal paste can be very detrimental.

Just make sure the GPU core is entirely covered and you can smooth it out a bit with a Q-tip swab. Apply Thermal pads MSI GT60 2QD Dominator 3K Edition EC necessary to guarantee contact of the larger chips with the heatsink. You can look at Talon's first post to see what it looks like or you can follow the same pad placement that Clevo used. Gently install the modified heatsink taking care to align the four install screws without dragging anything across the newly applied thermal paste and thermal pads. Screw the heatsink down in order see numbers right on the heatsink.

It should be screwed down tight. Optional - if you had removed the CPU heatsink you will need to follow the same process but with three screws and again make sure that you applied a thin layer of thermal compound to the entire core. Plug in the fan, set it in the proper place it sits easily and replace the one screw that holds it down. Replace the 6 screws to MSI GT60 2QD Dominator 3K Edition EC the back plate.


Replace the notebook battery. Boot up and Nvidia driver install The next steps may vary depending on whether you are successful with the previous steps and dependent on the version of Windows you have.


For this install we will assume Windows 8. If your machine boots to windows you can immediately tell if it's using your card by looking at the power button light orange if using Nvidia and blue if using Intel graphics.

Asus M3N78 SE ATK0110Categories
Acer Aspire 7530G Ralink WLANGaming Mouse
MSI CR700 Notebook HDMI AudioYou are here
Asus NX90SN Notebook Intel Turbo Boost MonitorSkyrim on MSI GT60 2OC

At this point your machine will either install the proper drivers since we never actually uninstalled the Nvidia drivers you already had on the machine or you will likely need to install Nvidia drivers. Check to see if the Nvidia Geforce experience is running in the taskbar.

If it is then your drivers installed and you can check Device Manager to see if it's properly recognizing your new card and the Integrated Intel graphics as well. If drivers were not installed automatically then Download the latest nvidia drivers and "Try" to install them.

  • MODARIA II - Modelling and Data for Radiological Impact Assessments
  • BIOS-Service-Center eBay Stores
  • BIOS-Service-Center
  • New Full Colorful backlit US keyboard for MSI GT60 2QD Dominator/3K Edition/4K Edition

It may fail but it will at least create the folders we will need for the next step. If the driver install fails create an inf file based on the post here The name in that post is actually wrong Driver folder which is 5 levels deep from c: It's about time I got something that would enable me to play harder and work harder on my channel. This means a lot more for you guys too! I'll see how it goes with shaders when recording.

Also expect to see a lot more game variety not just MC. Music by Approaching Nirvana http: The GT70 is a The GT60 houses the same specs but built under a Prices aren't set but do expect the units later on this month. Sorry about the quality. So i decided MSI GT60 2QD Dominator 3K Edition EC put some mods to this game well gtx still perform good. There are some hiccups because of recording otherwise game works fine no lag: Check out the video to see more! We appreciate it all. September Sky by Per Kiilstofte https: Pitch Black by Jens Kiilstofte https: Free Download MSI GT60 2QD Dominator 3K Edition EC Firmware 16F4EMS bit (Firmware). If your system BIOS version is E16F4IMS ~ E16F4IMS, please must update BIOS to E16F4IMSV before you update to the latest version g: EC.

Other Drivers